Access to routerlogin.net using Preset Wireless Security in JWNR2010v5 N300 Wireless Router has become faster. No longer you need to depend on the wired or wireless connection. The preset wireless security is unique to every router and the icing on the cake is that you can change the Preset Wireless Security name and password whenever you want after accessing the router login admin page. The process is to be followed in this way.
Netgear Setup for JWNR2010v5 N300 Wireless Router
- Start the Netgear Setup by un-packing the JWNR2010v5 N300 Wireless Router and place its antennas in standing position.
- Check your modem, if it has battery then remove it immediately and then put the battery back into the modem. Turn on the modem. It will take time to turn on till you can fix the Ethernet cable into the modem to JWNR2010v5 N300 Wireless Router’s yellow port.
- Power on the Router, its LED will light up which also takes time to boot up till you can connect your Router to your computer by utilizing an Ethernet cable
You can establish a connection between the computer and Netgear router using the Preset Wireless security.
Routerlogin.net Using Preset Wireless Security
Almost every router has a label or sticker at its bottom. There are some routers have the label attached to its backside. On this label, the preset SSID name and password is located. You can connect to your preset wireless security using manual or WPS method, any of these (if your device supports, WPS does not support to WEP device)
Following the manual method for preset wireless security, you can open the wireless connection managing software on your device. It will take time to scan the preset SSID name. When your router SSID name appears you can click on this and then type the preset password, you will be connected.
Following the WPS method, you need to press the WPS button on your router and immediately press the WPS button on your device you want to connect. Confirm the preset network name and password taken from the router’s bottom. Thus your computer or the device will get connected to the router.
Launch the main browser of your device to type http://www.routerlogin.net.
Confirm the username and password that is ‘admin’ in lower characters till you don’t set a new Netgear Router Password.
Successfully you will reach to Netgear routerlogin.net using the preset wireless security.
In order to change the preset wireless security, you can click on Wireless Setting > Change the Network Name > Select the WPA-PSK (AES) > Change the Passphrase. Make sure to save the settings.